A-96.250.231 / 130421
AMI Turbitrack
Installation
17
3.2. Install the AMI Monitor
The first part of this chapter describes the preparing and placing of
the system for use.
The instrument must only be installed by trained personnel.
Mount the instrument in vertical position.
For ease of operation mount it so that the display is at eye
level.
For the installation a kit containing the following installation ma
-
terial is available:
– 6 Screws 6x60 mm
– 6 Dowels
– 6 Washers 6.4/12 mm
Mounting re
-
quirements
The instrument is only intended for indoor installation. For
dimensions see figure
.
3.3. Connect Sample and Waste
3.3.1
FEP Tube at Sample Inlet
Use plastic tube (FEP, PA, or PE 4x6 mm) to connect the sample
line.
Mounting of
SERTO fitting
Push the flexible tube [A] into the Serto fitting [D] and tighten the
knurled nut [B].
A
B
C
D
E
Flexible tube
Knurled nut
Compression ferrule
Serto fitting
Flow cell
A
B
C D
E
