Suzuki GSX1300BKA, Supplementary Service Manual

Page: 105 / 108

Wiring Systems: 9A-7
1. Clamp
: Pass the radiator breather hose above the horn bracket. Be careful not to
contact the lead wires with the horn bracket.
15. Spacer
2. Clamp
: Bind the handlebar switch wiring harnesses. Cut off the excess end of the
clamp.
16. Cushion
3. Clamp
: Bind the side-stand switch lead wire, regulator/rectifier lead wire and fuel
tank drain hose with the clamp. Do not bind the fuel tank drain hose too tight.
17. Wiring harness No. 2
4. Clamp
: Bind the side-stand switch lead wire and regulator/rectifier lead wire at the
front of water bypass hose. Cut the excessive part of the clamp.
18. Right handlebar switch lead wire (Red)
5. Clamp
: Bind the left and right handlebar switch harnesses with the harness guide.
Cut off excess end of the clamp.
19. Left handlebar switch lead wire (Blue)
6. Clamp
: Face the clamp end inside.
20. Rear combination light lead wire
7. Clamp
: Cut off the excess end of the clamp and set the locked part facing inside.
21. Rear fender bracket
8. Harness guide
: Install the harness guide after binding the each lead wire.
22. Dealer mode coupler
9. Fixed clamp “A”: Do not make slacked part.
10. Harness guide “B”: Pass the left and right cooling fan and horn lead wires between the
frame and cylinder head.
11. Regulator/Rectifier lead wire “C”: Pass the starter motor lead wire to right side of the tool box.
12. Side-stand switch lead wire “D”: Bend the clamp half upward.
13. Water bypass hose “E”: Pass the rear brake light switch lead wire to inside of the ABS
brake pipes.
14. Ignition switch