Suzuki GSF600K1 2001, Service Manual

Page: 75 / 380

ENGINE 3-37
• Install the dowel pin, a new gasket and the starter clutch cover,
and tighten the cover bolts securely.
NOTE:
Install the gasket washer to the starter clutch cover bolt
A
as
shown.
$
Use a new gasket washer to prevent oil leakage.
• Install the oil pressure switch, apply the recommended bond to
its thread and tighten it to the specified torque.
*
99000-31140: SUZUKI BOND “1207B”
"
Oil pressure switch: 14 N.m (1.4 kgf.m, 10.0 lb-ft)
• Install the signal generator stator (along with the pickup coil)
1
.
• Be sure to fit the slot
B
on the back surface of the signal gen-
erator rotor over the locating pin
2
on the end of crankshaft.
NOTE:
The recommended bond should be applied to the groove of the
signal generator lead wire grommet
C
.
*
99000-31140: SUZUKI BOND “1207B”
• Hold the nut and tighten the signal generator rotor bolt to the
specified torque.
(
09900-00410: Hexagon wrench set
"
Signal generator rotor bolt: 25 N.m (2.5 kgf.m, 18.0 lb-ft)
• Connect the oil pressure switch lead wire.
• Pass the signal generator lead wire through the upper crank-
case as shown.