Suzuki GSF600K1 2001, Service Manual

Page: 74 / 380

3-36 ENGINE
• Install the clutch push piece
1
, clutch release bearing
2
and
thrust washer
3
onto the countershaft.
• Hold the starter clutch using the special tool, install the clutch
pressure plate, and then tighten the clutch spring set bolts in a
crisscross pattern to the specified torque.
(
09920-34810: Starter clutch holder
"
Clutch spring set bolt: 12 N.m (1.2 kgf.m, 8.5 lb-ft)
• Apply a light coat of the recommended bond to the clutch cover
gasket mating surface
A
as shown.
*
99000-31140: SUZUKI BOND “1207B”
• Install the dowel pins, a new gasket and the clutch cover.
• Tighten the clutch cover bolts securely.
NOTE:
Install the two gasket washers onto the clutch cover bolts
B
as
shown.
$
Use only new gasket washers to prevent oil leakage.
• Apply a light coat of the recommended bond to the starter clutch
cover gasket mating surface
C
as shown.
*
99000-31140: SUZUKI BOND “1207B”