Suzuki GSF600K1 2001, Service Manual

Page: 195 / 380

CHASSIS 5-31
REAR SPROCKET MOUNTING DRUM BEARING AND DUST
SEAL
• Install the new bearing and new dust seal using the special
tool.
%
09913-75520: Bearing installer
NOTE:
Apply SUZUKI SUPER GREASE “A” to the bearing and dust seal
lip before assembling the rear sprocket mounting drum.
For USA
&
99000-25030: SUZUKI SUPER GREASE “A”
For the other countries
&
99000-25010: SUZUKI SUPER GREASE “A”
REMOUNTING
Remount the rear wheel in the reverse order of removal.
Pay attention to the following points:
• Make sure that the brake disc is clean and free of any grease.
Apply THREAD LOCK SUPER “1360” to the brake disc bolts
and tighten them to the specified torque.
*
99000-32130: THREAD LOCK SUPER “1360”
"
Brake disc bolt: 23 N.m (2.3 kgf.m, 16.5 lb-ft)
• Tighten the rear sprocket nuts to the specified torque.
"
Rear sprocket nut: 50 N.m (5.0 kgf.m, 36.0 lb-ft)
NOTE:
The stamped mark
1
on the rear sprocket should face to the
outside.
• Adjust the drive chain slack after installing the rear wheel.
(
!
2-14)
• Tighten the rear axle nut
2
to the specified torque.
"
Rear axle nut: 100 N.m (10.0 kgf.m, 72.5 lb-ft)
• Install a new cotter pin. (For E-03, 28, 33)
• Tighten both chain adjuster nuts securely.
• After remounting the rear wheel, pump the brake pedal a few
times to check for proper brake operation.