Rev. 2.4
- 20 -
© 2014 Suzo-Happ Group
Bill-to-
Bill™ 300XE
After the switch has been removed, using a can of compressed air, spray each slit thoroughly. Also
spray all other surfaces including the gears end and the stepping end (index disk) of the switch. This
will prevent the dust from wearing the surface of the teeth on the gears and that of the index disk.
Finally, find the location sensor on the index disk and clean it using a new cotton swab.
Do no clean the gears using cleaners or the micro-fiber cloth. This will remove the lubricant
and will dramatically shorten the lifespan of the path switch.
It is paramount to install the switch properly back into the chassis to avoid serious damage to the
switch and Bill-to-
Bill™ 300XE unit.