Rev. 2.4
- 55 -
© 2014 Suzo-Happ Group
Bill-to-
Bill™ 300XE
6.4.
Recycling Cassettes (BBR-011X)
After an all round inspection is done to ensure no dents, scratches or cracks are present, the
recycling cassettes are first cleaned by following the same steps as in Levels 1 and 2 maintenance.
Next, open or unlock the recycling cassette cover (depending on the type of the recycling cassette
used different procedure is required). Inside each cassette two white, parallel tapes are found. Using
a soft blunt object, or ones finger pad press down each tape in a location where no wheels or drums
are present, press it up to 1” down. Some resistance should be felt. Then, by quickly removing the
object or ones finger, one should observe a spring-back effect of the tape (it should not remain loose)
Do not unwind the tape and ensure no oily residue is left on the tape to maintain proper
functioning of the recycling cassette (use of gloves is highly recommended)
If cuts or tears are found, contact a service center for replacement immediately