![background image](http://html1.mh-extra.com/html/suzohapp/bill-to-bill-300xe/bill-to-bill-300xe_serviceability-manual_1408250037.webp)
Rev. 2.4
- 37 -
© 2014 Suzo-Happ Group
Bill-to-
Bill™ 300XE
Next, using the Phillips screwdriver, unscrew the 4 bolts on each side of the dispenser.
Remove the cover slowly to ensure no internal components are moved and connectors unplugged
inside the dispenser.
There are two bearings holding the dispenser cover in place, one on each side. The latch on each
bearing should be moved away from the body of the dispenser and turned to point upwards. Then the
cover is lifter up and removed from the dispenser.
Use of excessive force will permanently damage the bearing and the latch mechanism. Only
lift the latch as far as needed to be able to freely turn the bearing (2cm off the surface).
Once the dispenser cover is removed, there is an easy access to the six belts and two sets of
sensors inside the dispenser. The same sensors that were cleaned using the cotton swabs in level 1