P/N: 670-00029A
2/17/12
4
USE OF TRAINED AND QUALIFIED PERSONNEL
System installation, operation,
and repair should only be done by persons having sufficient knowledge of the lift system
and the contents of this manual. In addition, they must have an understanding of all
warnings and precautionary measures noted in these safety instructions. Furthermore,
these individuals must be trained, instructed, and qualified to switch electrical circuits
and equipment on and off in accordance with applicable technical safety regulations.
AVOID HAZARDOUS ENVIRONMENT.
Do not operate the system outside. Do not
expose the system to damp or wet conditions. Avoid any chemical or corrosive
environments. Do not operate the system in the presence of flammable solvents,
propellants, and/or explosive materials (i.e. gas, vapor, dust, etc.) Avoid temperatures
outside of the system rated operating temperature range 41
°
to 113
°
F (5
°
to 45
°
C). Do
not subject lift system components to vibration and/or impact load conditions.
INSTALLATION SAFEGUARDS.
Do not use the system for any purpose other than
its intended function. Before operating system, make sure that the workstation has a
minimum clearance of 2 in. (51mm) from any other object or structure to prevent
pinching or crushing hazards. Do not allow wall, cabinet, electrical lines, hydraulic or
pneumatic lines, or any other fixed structures to obstruct the movement of the
workstation during operation.
KEEP CHILDREN AWAY.
It is not recommended that children operate this
electrically powered lift device. If this device is used by or near children, close
supervision is absolutely necessary.
OBSERVE DUTY CYCLE.
The term duty cycle refers to the amount of time that a
motor or system is in motion versus the amount of time that it is resting. The Movotec
®
Q-Drive ATU Lift System is not designed to operate continuously without rest. It is
designed for intermittent use only and is rated for a 10% duty cycle. This means that if
the lift system is in motion for 1 minute, it must be at rest for at least 9 minutes before the
next operation. It is also important to note that the maximum system on-time is 1 minute.
To avoid damaging the system, the duty cycle must not be exceeded. Motor surfaces
can become warm after extended operation that exceeds the duty cycle. Provide adequate
ventilation to allow heat dissipation from within and around lift system components.
USE OF ACCESSORIES.
Use caution when routing extension cords. Do not allow
cords to become pinched or stretched. Avoid positioning cords where they can become a
trip hazard. Use only spare parts and accessories authorized or supplied by Suspa
®
Incorporated. Do not replace or replenish lift system hydraulic fluid unless the fluid is
supplied by Suspa
®
Incorporated
.
DO NOT INSERT OBJECTS.
To reduce the risk of fire or electrical shock, do not
insert any objects into the system when powered.
