P/N: 670-00029A
2/17/12
24
•
Using appropriate screws, mount the motorized pump assembly to the surface.
Please note that mounting screws are not provided with system or workstation kit.
To avoid deforming the plastic housing, it is recommended to use washers when
installing the motor bracket fasteners.
•
Check mounting screws to ensure that the unit is secured.
7.8 Motor Controller Installation
There should be enough power cord length to facilitate movement of the workstation
without the power cord connector becoming separated from the motor controller during
operation. To accomplish this and to ensure that there is enough power cord length to
reach a power receptacle, the motor controller should be placed toward the center and
backside of the workstation. In addition, the motor controller should be placed so that it is
in relatively close proximity to the gear motor. If this is not possible, Suspa
®
Incorporated
offers motor extension cables to make up the difference. These cables can be purchased
on our website at
http://movotec.com
.
•
Place the motor controller in the desired location, ensuring that the motor cable is
long enough to reach the motor ports after installation is complete.
(Motor-Cable not shown)
•
Mark and prepare (2) mounting holes for the control box
•
Install controller using mounting screws, and check to ensure that the unit is
secured.
7.9 Surface Mount Switch Installation
•
Place the low-profile switch in the desired location on the underside of the work
surface.
