P/N: 670-00029A
2/17/12
29
8.2 Connecting to Power
Prior to connecting system to power, make sure that the
power supply voltage matches motor controller nameplate
and all cables are fully connected to the correct electrical
ports.
•
Connect the power cord to a power outlet. The motor controller will produce an
audible double-click when power is applied.
8.3 First Operation
If the lift system does not start promptly and operate as
explained after the first operation, perform the
System Reset
Procedure
in
Section 8.8
of this manual. If the problem
cannot be easily corrected, disconnect the system from power
immediately and contact Suspa
®
Incorporated technical
support.
Suspa
®
Incorporated assembles and tests every Movotec
®
Q-Drive “ATU” Lift System
before it leaves our manufacturing facility to make sure that it functions correctly. If the
unit is installed correctly, the system should be ready to operate at first operation.
However, there are a few very important items to note about how the Movotec
®
Q-Drive
motor works and what to expect during the first operation.
The Movotec
®
Q-Drive gear motor is equipped with a pair of hall-effect sensors that
sense the direction of gear motor shaft rotation and the number of shaft rotations. When
the gear motor is in operation, these hall-effect sensors are constantly sending this
information in the form of electrical pulses to the motor controller. The motor controller
interprets these electrical pulses and shuts the gear motor off just before the
