P/N: 670-00029A
2/17/12
30
preprogrammed pump upper and lower mechanical limits are reached. If the motor
controller does not receive these electrical pulses during operation, the system could
malfunction. Therefore, it is absolutely critical that the motor cable connections remain
intact in order for the system to function correctly.
All Movotec
®
Q-Drive “ATU” Lift Systems are shipped with the pump in the retracted
position, approximately 0.12 in. (3mm) above the lowest mechanical limit. A similar gap
will exist on the upper end of the stroke; this space has been programmed into the motor
controller to prevent the pump from bottoming out in the extended and retracted positions
during operation.
If technical support is needed, or any questions exist before operation, system
information can be found using the product labels located on the side of the pump
(reference photographs below).
Do not dismantle the system unless authorized by Suspa
®
Incorporated. Attempting to repair the system or system
components without authorization from Suspa
®
Incorporated
voids the warranty.
NOTICE
