Supero SuperWorkstation 5035B-T, User Manual

Page: 53 / 118

Chapter 5: Advanced Serverboard Setup
5-25
5-12 Parallel, Floppy, IDE, and SATA Ports
Use the following information to connect the IDE hard disk drive cables.
A red mark on a wire typically designates the location of pin 1.
The 80-wire ATA100/66 IDE hard disk drive cable that came with your system
has two connectors to support two drives. This special cable should be used
to take advantage of the speed this new technology offers. The blue connector
connects to the onboard IDE connector interface and the other connector(s) to
your hard drive(s). Consult the documentation that came with your disk drive for
details on actual jumper locations and settings for the hard disk drive.
•
•
Parallel (Printer) Port Connector
The parallel (printer) port is located
on the I/O backplane. See the table
on the right for pin defi nitions.
Parallel (Printer) Port Connector
Pin Defi nitions
Pin# Defi nition Pin # Defi nition
1 Strobe- 2 Auto Feed-
3 Data Bit 0 4 Error-
5 Data Bit 1 6 Init-
7 Data Bit 2 8 SLCT IN-
9 Data Bit 3 10 GND
11 Data Bit 4 12 GND
13 Data Bit 5 14 GND
15 Data Bit 6 16 GND
17 Data Bit 7 18 GND
19 ACK 20 GND
21 BUSY 22 Write Data
23 PE 24 Write Gate
25 SLCT 26 NC
SATA Ports
There are no jumpers to confi gure the
onboard SATA connectors. See the
table on the right for pin defi nitions.
SATA Port
Pin Defi nitions
(I-SATA0 ~ I-SATA5
)
Pin # Defi nition
1 Ground
2 TXP
3 TXN
4 Ground
5 RXN
6 RXP
7 Ground