SuperServer 9029GP-TNVRT User's Manual
88
I/O inactivity, and will return the link to an active state when I/O activity resumes. The options
are Enable and
Disable
.
sSATA Port 0 – sSATA Port 7
Hot Plug
Select Enable to support Hot-plugging for the device installed on a selected SATA port
which will allow the user to replace the device installed in the slot without shutting down
the system. The options are
Enable
and Disable.
Spin Up Device
On an edge detect from 0 to 1, set this item to allow the SATA device installed on the SATA
port specified by the user to start a COMRESET initialization. The options are Enable and
Disable
.
SATA Device Type
Use this item to specify if the device installed on the SATA port selected by the user should
be connected to a Solid State drive or a Hard Disk Drive. The options are
Hard Disk Drive
and Solid State Drive.
PCIe/PCI/PnP Configuration
The PCI Bus Driver Version is displayed:
PCI Devices Common Settings
Above 4G Decoding
(Available if the system supports 64-bit PCI decoding) Select Enabled to decode a PCI device
that supports 64-bit in the space above 4G Address. The options are
Enabled
and Disabled.
SR-IOV Support
(Available if the system supports Single-Root Virtualization) Select Enabled for Single-Root
IO Virtualization support. The options are Enabled and
Disabled.
MMIO High Base
Use this feature to select the base memory size according to memory-address mapping for
the IO hub. The base memory size must be between 4032G to 4078G. The options are
56T
,
48T, 24T, 16T, 4T, and 1T.
MMIO High Granularity Size
Use this feature to select the high memory size according to memory-address mapping for
the IO hub. The options are 1G, 4G, 16G, 64G, 256G, and
1024G
.