SuperServer 9029GP-TNVRT User's Manual
52
Checking the Temperature of an NVMe Drive
There are two ways to check using IPMI.
Checking a Drive
•
IPMI > Server Health > NVMe SSD –
Shows the temperatures of all NVMe drives, as in
Figure 3-4.
•
IPMI > Server Health > Sensor Reading > NVME_SSD –
Shows the single highest
temperature among all the NVMe drives.
Installing M.2 SSDs
The system supports two M.2 solid state storage drives of form factor 2280 or 22110.
1. Power down the system as described in Section 3.1, and remove the head node
(motherboard) tray.
2. Locate the M.2 slots (M.2-P1, M.2-P2) on the motherboard.
3.
The M.2 card will be held in place by a plastic standoff/holder already installed on the
motherboard. Depending on the form factor of your card, you may need to move it. If
necessary, move it so that your card just fits between the slot on the motherboard and
the standoff.
4.
In the plastic standoff, pull out the top plug.
5. Slip the M.2 card into the slot on the motherboard, then trap the other end of the card
with the standoff plug by reinserting it.
Figure 3-17. Locating M.2 Positions
M.2