SUNWARD SWE150F, Operation & Maintenance Manual

Page: 15 / 216

8
（
6
）
Wiper label
Properly use wiper.
（
7
）
Filter core safety label
Replace pilot oil filter every 400 hours
 Stop machine on a firm and level ground.
 Lower bucket to the ground.
 Run engine at low-speed for 5 minutes.
 Shut down engine, remove the key.
 Relieve internal pressure which builds up in
hydraulic system by means of left/right pilot
joystick.

Set pilot control lever in LOCK (UP) position.
 Use wrench for filter to remove filter housing
off the filter head cover by rotating
counterclockwise.
 Remove filter core and used 0-ring.
 Clean the area in contact by head cover and
o-ring.
 Apply a new layer of fresh hydraulic oil, and
place it in position.
 Lubricate new filter core with a thin layer of
clean hydraulic oil on the ring section. Push
filter core upward while moving it forward and
backward alternately to install it.
 Clean filter housing.

Rotate clockwise to tighten filter shell to head
cover. Tighten at torque: 19.5—29.5Nm (2-3
kgfm).