29
APPENDIX G - Platinum Plus Housing Adjustment
Adjust the pitch of the Semi-Cassette Housing
1.
Loosen the two locknuts on Central Support of the
Housing (located at the mid-point of the Awning) to
allow the Support to rotate. See Figure 30.
2.
Loosen the two Allen Set Screws on the End Caps,
but do not remove (see
Figure 31
). If removed, screw
back into the threaded holes enough to hold the
Screws in place. Do this on both ends of the Housing.
3.
Rotate the Housing as desired (see Figure 31).
Sunsetter recommends the front leading edge of the
Housing touch the Fabric while closing.
4.
Tighten the two Allen Set Screws on the End Caps.
5.
Tighten the two locknuts on the Central Support.
Platinum Plus Housing
End Cap
4mm Allen
Set Screws
Figure 31
Figure 30
Central Support
Two Locknuts
and 5mm Bolts
