No. 7, Road 12, Industrial Zone, Taichung City 407, Taiwan
Tel: 886-4-2359-1190 Fax: 886-4-2359-3409
[email protected] www.sunriseiw.com.tw
3
8.
If any problem or abnormal condition arises during operation, stop the machine
immediately(push the emergency button) and report to a supervisor. Do not turn
on the machine again until the problem is rectified by qualified personnel.
9.
The machine should never be left under power when not in operation or
unattended. After completing of work, always isolate the machine power supply
after turned the power off.
10.
After completion of operation, all slugs and waste materials must be cleaned
away from the machine.
11.
Regularly check tooling for defects and wear to ensure safety and maintain good
condition.
12.
Use handling equipment when lifting heavy tooling and materials.
13.
Never exceed the rated capacity of the machine. Refer to the specification chart
for details.
The manufacturer shall not be held any liability for damages/body injuries or
other consequences to machine, material, and persons caused by the non-
compliance of the above safety precaution procedures, in particular for the
following situations:
1.
Non-use of the two-hand switches or use of foot switch without safety
protections.
2.
Did not wear protective glasses for the eyes.
3.
Did not interrupt the main electric power supply before any maintenance
work.
4.
Damage of electric parts due to incorrect electric power supply.
5.
Warning sign as follows
