No. 7, Road 12, Industrial Zone, Taichung City 407, Taiwan
Tel: 886-4-2359-1190 Fax: 886-4-2359-3409
[email protected] www.sunriseiw.com.tw
10
OPERATING MODES
In MANUAL mode
, press the two-hand switch together for the forward motion of
the cylinder. The cylinder slows down at the Slow position and stops at the
Forward position. Releasing the switches and the cylinder retract to the Back
position, and the controller moves to the next Step in the Program. After finish the
last Step set by the End parameter, the controller moves back to the first Step in the
Program. Place the next work piece and start from the first step(bend).
In AUTO mode
, press the two-hand switch together and hold. The cylinder will
move back and forth between the Back and Forward position. Releasing the
switches and the cylinder retract to the Back position. The controller does not move
to the next Step in this mode.
In JOG mode,
press the two-hand switch together for the forward motion of the
cylinder. The cylinder goes only forward and does not retract. Press the BACK
button for the backward movement of the cylinder. This mode is useful to set the
required cylinder stroke length for the required bend.
PRESSURE SETTING
In certain work job, the pressure of the cylinder need to be adjusted to a lower level,
the pressure can be adjusted by the pressure value in the machine base. A pressure
gauge is included to indicate the pressure.
