Sun Microsystems STOREDGE A5000, Installation And Service Manual

Page: 75 / 146

Chapter 6 LED Indicators 6-7
6.6 Disk Drive
The disk drive LEDs are located on the disk array beneath the disk drive slots.
FIGURE 6-7
Disk Drive LEDs
TABLE 6-6
Disk Drive LEDs
Ready Fault Indication Corrective Action
The disk drive is ready and active. None
The disk drive is ready, but not active. None
The disk drive is becoming ready or
spinning down in preparation for
removal. None
The disk drive slot is identified and
disk drive can be inserted or removed. Insert or remove the disk drive.
N/A Fault condition Replace disk drive. See
Section 7.2.1 “Disk Drive” on
page 7-3.
The disk drive is not installed.
The disk drive is improperly inserted.
There is no power to disk drive.
The disk drive is turned off.
Disk drive power sequencing in is
progress.
Install the disk drive if required.
Reinsert the disk drive.
Verify that the system power is
on.
Turn on the disk drive if required.
The disk drive ready LED should
start flashing within 30 seconds.
Rapid flashing On
Flashing Off
Disk drive ready
Disk drive fault