Page 12
Induction Range (IR) Series
Induction Range (IR) Series
Electronics
2-12
#827176 - Revision A.2 - September, 2017
User Options Mode
User Options Mode is used to set certain functions of the cooktop to the user’s preference.
Entering User Options Mode
Cooktop must be in Idle Mode.
•
Touch and hold
ALL OFF
pad for 5 seconds.
•
After 5 seconds a valid selection beep sounds alerting the user to remove their finger.
•
If any other key pad sensor detects a signal, User Option Mode does not engage.
•
If the
ALL OFF
pad is not released after 7 seconds, User Option Mode does not engage.
•
Power to all hobs is disabled in User Option Mode.
•
If after 60 seconds no inputs are detected while in User Option Mode, the control returns to Idle Mode.
•
If the
ALL OFF
pad is touched at any time while in User Option Mode, the control returns to Idle Mode.
•
Use the
“+”
and
“-”
pads to step through the settings.
•
Left rear
“…”
display advances one LED for each setting. The number of
“...”
on identifies which setting is
•
being adjusted.
User Options
a.
Annunciator Volume
One
“.”
displayed on of the left rear control zone.
•
Uo
displayed on the 2-digit display.
•
The
“.”
displayed on the front left control zone show the current volume level.
•
Power level 1 for low, power level 5 for medium, and power level 10 for high.
•
Touch the front left control zone
MLT/SIM
pad or
HI
pad to adjust the volume up or down.
•
As the volume is adjusted, the annunciator sounds a tone at the newly selected setting.
•
A touch of the
“+”
pad advances the user options mode to Annunciator Frequency.
•
b.
Annunciator Frequency
Two
“.”
displayed on of the left rear control zone.
•
Fr
displayed on the 2-digit display.
•
The
“.”
displayed on the front left control zone shows the current frequency level.
•
Power level 1 for low, power level 5 for medium, and power level 10 for high.
•
Touch the front left control zone
MLT/SIM
pad or
HI
pad to adjust the frequency up or down.
•
As the frequency is adjusted, the annunciator sounds a tone at the newly selected setting.
•
A touch of the
“+”
pad advances the user options mode to Auto-Lock.
•
c.
Auto-Lock
Auto-lock function is enabled by default.
•
If disabled, the cooktop does not automatically enter lock mode after 10 minutes of continuous idle mode.
•
Three
“.”
displayed on of the left rear control zone.
•
Lo
is displayed in the 2-digit display.
•
Touch the left front control zone
MLT/SIM
pad to disable the auto-lock function. The front left control zone
•
power level changes to level one..
Touch the left front control zone
HI
pad to enables the auto-lock feature. The front left control zone power
•
level changes to level ten.
