Page 37
Component Access & Removal
International Dual Fuel (ICBDF) Series
International Dual Fuel (ICBDF) Series
4-7
#814889 - Revision A - July, 2010
Figure 4-12. Thermostat Support, Electrode and IR
Weld Assembly Removal.
Figure 4-11. Griddle Plate Removal.
Infrared Griddle Components
Grease Tray, Griddle Plate, Thermostat Support
Assembly, Electrode, IR Weld Assembly, Infrared
Burner, Thermostat, Solenoid and IR Orifice
Grease Tray and Griddle Plate Removal
The griddle plate is a cast iron plate that rests on top of
the griddle weld assembly. A grease tray sits in the well
of the griddle. For cleaning purposes, it tilts up from the
front edge for removal. An edge has been added to the
lip of the cooking surface, which helps in the removal of
the plate for cleaning and servicing. To remove the grid-
dle plate, lift the front edge of the plate from underneath
the cooking surface lip. Now, place both hands under the
plate and lift it off (See
Figure 4-11
).
Thermostat Support Assembly Removal
The thermostat sits in the trench of the thermostat assem-
bly. Pull the tip back toward the control panel until it
releases from the notch of the support assembly. Now, lift
the thermostat up and maneuver the capillary tube out of
the notch at the rear of the IR weld assembly. Then,
extract the screws at the front and rear of the thermostat
support assembly and lift out (See
Figure 4-12
).
Electrode Removal
First disconnect the electrode lead from the DSI board.
Now, extract the screws from the electrode bracket.
Then, pull the electrode with lead through the oblong hole
in the IR weld assembly (See
Figure 4-12
).
IR Weld Assembly Removal
Extract the screws from either side of the IR weld assem-
bly, lift the front edge and rest it on the shield that pro-
tects the ECH. Use a wrench to remove the gas line from
the orifice elbow (See
Figure 4-12
).
Infrared Burner Removal
First remove the screw securing the infrared burner to the
IR weld assembly. Now, using an adjustable wrench, dis-
connect the gas line from the orifice elbow (See
Figure 4-
13
). Then, lift theIR burner out from the IR weld assem-
bly.
Figure 4-13. Infrared Burner Gas Line Removal.
