Page 20
International Dual Fuel (ICBDF) Series
International Dual Fuel (ICBDF) Series
Operation & Electronic Control
3-10
#814889 - Revision A- July, 2010
Time of Day Clock
The clock can be visible on the display during all modes.
To set clock, press CLOCK key on display panel, “CLOCK”
will flash on and off. Next, press up or down arrow key to
increase or decrease time. Stop when correct time of day
shows in display window (See
Figure 3-4
). Press the
CLOCK key or ENTER key to set clock. Two beeps will be
heard when time has been entered.
NOTE
:
By holding down desired arrow key, the counter will
rapidly toggle through the numbers. The time will change
from am to pm by passing the 12:00 mark (A for am and P
for pm?).
Oven Timer
The oven has a timer that operates independently from the
oven controls. Once a time is set in hours and minutes, the
countdown is seen in the display window. Only the last
minute counts down in seconds. To initiate oven timer,
press TIMER key (See
Figure 3-5
). Next, press up or down
arrow key to increase or decrease desired amount of cook-
ing time in hours and minutes (See
Figure 3-5
). Press
ENTER key or TIMER key to start timer. Two beeps will be
heard. The oven will chime, time will continually flash when
timing is complete. To exit oven timer function, press
TIMER key, then press CLEAR key twice to clear time and
return to clock.
THREE FIELD OPTION MODES
Three Field option modes allows for the user to adjust or
change specific option’s of the ECH and oven controller,
such as User Preference Offset, 12 hour to 24 hour clock
and Celsius to Fahrenheit temperature.
Changing Clock to 24 Hours
To set 24 hour clock, press and hold CLOCK key for 5 sec-
onds (See
Figure 3-5
). Now, press CLOCK key again to
change from 24 hour to 12 hour or vice versa (See
Figure
3-5
). Then, press ENTER or after a short delay the clock
will set by default.
UPO (User Preference Offset)
This option allows the user to offset a specific oven temper-
ature ± 2° in 1°C (Celsius) increments. To initiate, press
and hold the CLOCK key for 5 seconds. The current UPO
will be displayed in the temperature readout knob, turning
the knob at this point you can change the UPO. Turn the
knob to the left or right to increase or decrease the UPO in
1° increments as much as ± 2° (See
Figures 3-7
and
3-8)
.
Celsius to Fahrenheit
The oven can be changed from Celsius to Fahrenheit tem-
perature or visa versa. To initiate, press and hold CLOCK
key for 5 seconds. Now, press COOK TIME key to change
from °C and °F or visa versa (See
Figure 3-9
). Next, press
ENTER key or after short delay °C or °F will set by default.
Figure 3-4. Press and Hold CLOCK Key for 5 Seconds.
Then, Press Up or Down Arrow Key to Set Time.
Figure 3-6.
Press and Hold CLOCK Key for 5 Seconds. Then,
Press CLOCK Key to toggle between 12hr and 24hr.
Figure 3-5. Press TIMER Key. Then, Use Up or Down
Arrow Key to Set Desired Amount of Time.
Figure 3-9.
Press and Hold CLOCK Key for 5 Seconds. Then,
Press COOK TIME Key to Toggle between °C and °F.
178
Figure 3-7.
Turn Knob to Right to
increase temp.
177
Figure 3-8.
Turn Knob to Left to
decrease temp.
