Stryker SV1, Operation Manual

Page: 50 / 1124

E En ng glliis sh h
E EN N
1-44 KK-7100 REV 02 www.stryker.com
EMC information
Guidance and Manufacturer’s Declaration - Electromagnetic Emissions
SV1 is intended for use in an electromagnetic environment specified below. The customer or the user of SV1 should
assure that it is used in such an environment.
Emissions Test
Compliance Electromagnetic Environment
RF Emissions
CISPR 11
Group 1
SV1 uses RF energy only for its
internal function. Therefore, its RF
emissions are very low and are not
likely to cause any interference in
nearby electronic equipment.
RF Emissions
CISPR 11
Class A
SV1 is suitable for use in all
establishments other than domestic
and those directly connected to the
public low voltage power supply
network that supplies buildings used
for domestic purposes.
Harmonic Emissions
IEC 61000-3-2
Class A
Voltage Fluctuations
Flicker Emissions
IEC 61000-3-3
Complies
Guidance and Manufacturer’s Declaration - Electromagnetic Immunity
SV1 is suitable for use in the electromagnetic environment specified below. The customer or the user of SV1 should
assure that it is used in such an environment.
Immunity Test
IEC 60601 Test Level
Compliance Level
Electromagnetic
Environment Guidance
Electrostatic Discharge
(ESD)
IEC 61000-4-2
+6 kV contact
+8 kV air
+6 kV contact
+8 kV air
Floors should be wood,
concrete, or ceramic tile. If
floors are covered with
synthetic material, the
relative humidity should be
at least 30%.
Electrostatic fast Transient/
burst
IEC 61000-4-4
+2 kV for power supply
lines
+1 kV for input/output lines
+2 kV for power supply
lines
+1 kV for input/output lines
Main power quality should
be that of a typical
commercial or hospital
environment.
Surge
IEC 61000-4-5
+1 kV differential mode
+2 kV common mode
+1 kV differential mode
+2 kV common mode
Main power quality is that
of a typical commercial
and/or hospital environment.