Struers Exotom 100, Instruction Manual

Page: 5 / 247

Exotom-100
Instruction Manual
Exotom-100
Safety Precaution Sheet
To be read carefully
before use
1. The operator(s) should be fully instructed in the use of the machine and its cut-
off wheels according the Instruction Manual and the instructions on the cut-off
wheels.
2. Use the supplied Allen key to remove the two red transport screws at the rear of
the machine. Do not attempt to open the protection guard before the screws
have been removed.
3. The machine must be placed on a safe and stable support. All safety functions
of the machine must be in working order. The machine must be levelled by
means of the adjustable legs provided.
4. The unit must be installed in compliance with local safety regulations.
5. Prior to lifting the unit by the built-in truck lifting point, ensure that the boom is
properly secured with the locking pins provided. Before transport, secure the
cutting arm with the locking system provided.
6. To achieve maximum safety and lifetime of the machine, use only original
Struers consumables.
7. Use only intact cut-off wheels. The cut-off wheels must be approved for a
spindle speed of min. 1950 rpm / 42 m/s. Do not use sawblades.
8. Observe the current safety regulations for handling, mixing, filling, emptying and
disposal of the additive for cooling fluid.
9. The workpiece must be securely clamped in the quick-clamping device or the
like. Large or sharp workpieces must be handled in a safe way.
10. Struers recommend the use of an exhaust system as the cutting materials may
emit harmful gasses or dust. See the instructions of the cut-off wheel.
11. The machine emits only moderate noise. However, the cutting process itself
may emit noise, depending on the nature of the workpiece. In such cases, use
of hearing protection is recommended.
12. The machine must be disconnected from the mains prior to any service.
13. Ensure that the cut-off wheel is secured before working on or around the cutting
table.
14. Do not put hands through the rubber curtain during operation of the machine.