Struers Exotom 100, Instruction Manual

Page: 20 / 247

Exotom-100
Instruction Manual
14
Toggle between the four Cutting Modes, by pressing the
CUTTING MODE button. The selected mode, Direct Cutting,
ExciCut, AxioCut/Step or AxioCut/Sweep, appears on the top bar
of the Cutting Display.
Toggle between the three Cutting Parameters by pushing the
knob. The highlighted Cutting Parameter is selected.
Actual values of the Cutting Parameters FEED, FORCE and
STOP are displayed on top of the columns (
A
).
The actual position of the cut-off wheel (relative its starting
position) is displayed graphically by the small icon
to the right
of the STOP column.
Turn the knob to change the setting of the selected Cutting
Parameter. The arrow on the left of the column will move to
reflect the new setting (
B
).
By moving the pointer of the STOP column below the column,
AUTO mode is selected.
The highlighted area of the bar graphs TEMP and LOAD, shows
the status of the cutting motor:
TEMP.
Temperature indicator of the cutting motor.
LOAD.
Load indicator of the cutting motor.
To increase the lifetime of the display, the backlight is
automatically switched off if Exotom-100 has not been used for 15
min. Push any key on the Control Panel to re-activate the
backlight.
Changing Cutting Mode and
Cutting Parameters
Changing Cutting Mode
Changing Cutting Parameters
Push knob to select Cutting
Parameter.
Turn knob to adjust setting.
Reading the Motor Information
Sleep Mode
B
A