Struers Exotom 100, Instruction Manual

Page: 14 / 247

Exotom-100
Instruction Manual
8
Before connecting the machine, check that the mains voltage is
correct by referring to the type plate.
Open the electric connection box and connect a 4-lead cable in the
following way:
PE: earth
L1: phase
L2: phase
L3: phase
Press the knob for the spindle lock on the left-hand side of the cut-off
wheel, while turning the cut-off wheel until the spindle lock clicks.
Remove the nut with a fork spanner (30mm).
Remove the flange and the cut-off wheel.
Mount the new cut-off wheel with a cardboard flange on each side.
Mount the flanges and nut. Tighten carefully.
To check that the cut-off wheel rotates in the direction indicated
on the wheel-guard, do the following:
Close the protection hood.
Turn Main Switch to On.
Press START
s
.
Check the rotational direction of the wheel.
Press STOP o .
If the direction of rotation is incorrect, turn mains off and switch
two of the phases.
Struers recommends the use of an exhaust system as workpieces
may emit harmful gases when cut. The unit is prepared for
connection to an exhaust system via an 80 mm fitting on the left
hand side of the cabinet.
Recommended capacity for exhaust system: 350m
3 /h at 0mm
water gauge.
Power Supply
IMPORTANT
Check that the mains voltage corresponds to the voltage stated on the type
plate on the side of the machine.
Mounting the Cut-off wheel
Direction of the Cut-off Wheel
Connection to an External
Exhaust System
ee
Nut
Flange
Washer