Operation
Sherpa 120, 140 | 06.19
113
7.8
Discharge fodder
Important information for fodder discharge:
•
Open the dosage gate completely when discharging very
dry, long-stalk and highly structured fodder.
•
Open the dosage gate according to the desired discharge
quantity when discharging highly pourable fodder.
•
The opening width of the dosage gate is indicated by the
height of the yellow bar (1) for the respective dosage
gate.
–
Black display field: Dosage gate is closed. No fodder
discharge.
– Display field completely yellow: Dosage gate is
completely open. Maximum fodder discharge.
•
Extend the counter-cutter in front of the discharge
opening a little into the mixing container to improve the
homogeneous flow of the fodder material.
•
If blockages occur during fodder discharge, immediately
stop the mixing process and eliminate the blockage.
•
Increase the drive speed of the mixing auger for a short
time towards the end of the discharging process to throw
off any fodder residues from the mixing auger and to
completely empty the mixing container.
– Gear level II
Fig. 90
The fodder discharge can be started after the mixing process
has been finished.
The fodder quantity discharged onto the feeding table is set
via
•
the drive speed of the mixing auger.
•
the opening width of the dosage gate.
•
the travelling speed of the machine on the feeding table.
The higher the drive speed of the mixing auger, the wider the
opening width of the dosage gate, and the slower the
travelling speed of the machine, the larger the fodder quantity
discharged onto the feeding table.
Summary of Contents for Sherpa 120
Page 2: ......