83
5.
Clean and inspect the surface around the locating pins. Make sure that the tip
wipe assemblies can sit flush on the surface.
6.
Inspect the flicker portion of the tip wipe assemblies. The top edge of the flicker
should be straight and must not contain excessive notching/wear.
7.
Inspect the brush portion of the tip wipe assemblies. Brush bristles must not show
evidence of wear (i.e. no notches in bristle pattern) and should not contain
significant bristle clumping. Frayed bristles are acceptable as long as the top edge
is even across all of the bristles.
8.
Replace one or both of the tip wipe assemblies if excessive wear is present.
•
The components of the assembly cannot be replaced individually. The entire tip wipe
assembly must be replaced if excessive wear is present on the flicker or the brush.
9.
Reinstall the support side tip wipe assembly by placing the assembly onto its
locating pins and sliding the assembly downward.
10.
Repeat step 9 to reinstall the model side tip wipe assembly.
Tip Wipe Assembly
Flicker
Brush
