Eden260V User Guide
6 Operating and Maintaining the Printer
DOC-32020 Rev. F
6-12
Changing the Printing Material
Before producing models using a different type of printing material than is
currently installed, run the Material Replacement wizard to flush the print block
and feed tubes.
You should carefully plan printing models with different materials to avoid
unnecessary waste of the materials currently loaded. The amount of material
flushed depends on the flushing cycle chosen and if you are replacing one or
both Model cartridges.
Note:
When performing manual material replacement, certain replacement
options are blocked to protect the system. In these cases, follow the
recommendations of the Material Replacement wizard for best replacement
options.
To replace the printing material with the wizard:
1. Start the Material Replacement wizard from the
Options
menu.
Figure 6-8 Starting the Material Replacement wizard
2. In the opening screen, click
Next
.
3. If the printer cover is not closed, a screen appears, prompting you to close the
cover. Confirm that it is closed and click
Next
.
