Eden260V User Guide
6 Operating and Maintaining the Printer
DOC-32020 Rev. F
6-67
15.Inspect the new UV reflector, and make sure that a black strip is attached to
the inside of it. If not, install one—on the side of the reflector
opposite
(not
next to) the print block.
Note:
Extra black strips are included in the printer Start-Up Kit. If necessary,
you can remove the black strip from the old reflector and install it in the new
reflector (as long as the black paint has not faded).
16.Discard the old UV reflector and lamp.
Dispose of the used UV lamp in accordance with environmental and safety
requirements.
Warning: Broken UV lamp hazard
UV lamps contain mercury. Deal with broken lamps with caution.
l
Ventilate the room thoroughly.
l
Use protective gloves when collecting mercury and lamp components.
l
Remove spilled mercury with a method that prevents the generation of
mercury vapor, such as a syringe, packing tape or paper.
l
Place the broken lamp, mercury and contaminated materials in an air-tight,
non-metallic container.
17.Insert the UV reflector unit into the housing, next to the print block.
Figure 6-105 Print block and UV lamp assembly, showing correct
placement of black strip
