Eden260V User Guide
2 Safety
DOC-32020 Rev. F
2-5
UV Radiation
The UV lamps used in the printer emit dangerous radiation
➢
If the UV lamps remain on when the printer is open, do not stare directly at the
UV light. Shut down the printer and call your Stratasys service provider.
Printer Maintenance
➢
Service operations should be performed only by qualified personnel who
have been instructed in relevant safety precautions.
➢
Notify co-workers and those who have access to the printer before beginning
non-routine and hazardous work.
Report any potential dangers and safety-related accidents to your safety
officer or to other appropriate authorities.
Model and Support Materials
Model and Support materials are made of chemical substances. Although
precautions must be taken when handling these materials directly, all Model and
Support materials used by the printer are handled in sealed cartridges. Normally,
operators of the printer should never be directly exposed to hazardous materials.
In the unlikely event of a leak or spill, follow the instructions that are included with
the material cartridges used.
➢
Store Model and Support materials indoors, in a dry area with adequate
ventilation, between 15-25 degrees Celsius (59-77 degrees Fahrenheit).
Never expose them to flames, heat, sparks, or direct sunlight.
➢
Keep Model and Support materials away from areas where food and drink
are stored, prepared and consumed.
➢
Uncured printing material is considered a hazardous substance, requiring
certain precautions when directly handling it. To prevent skin irritation, wear
neoprene
or
nitrile gloves
. If there is any chance that Model and Support
materials might splash into the eyes, wear safety goggles. Prolonged direct
contact with printing materials can cause an allergic reaction.
➢
When handling UV-cured models that may not be completely cured on the
surface, common latex gloves are adequate.
➢
To prevent respiratory irritation, ventilate areas where Model and Support
materials are used. If the printer is not equipped with an exhaust duct, the
room ventilation system should replace the air 4–6 times per hour.
➢
Clean up Model-material and Support-material spills with disposable towels
or other absorbent, non-reusable material, such as sawdust or activated
charcoal. Rinse the spill area with denatured or isopropyl alcohol (IPA),
followed by soap and water. Dispose of the absorbent material in accordance
with local regulations.
➢
Do not wash contaminated clothing at home; clothing should be
professionally laundered.
