Storz 20711620-1, Instruction Manual

Page: 75 / 108

67
Error message Cause Solution
1 = E01: NO VRAM ERROR Parameters not stored successfully Switch device off/on. Default values are loaded.
When not successful, send device for repair
2 = E02: MOTOR OUTPUT FAILURE Overload on the motor controller Switch device off/on. If not successful, send
device for repair
3 = E03: –
4 = E04: –
5 = E05: –
6 = E06: –
7 = E07: –
8 = E08: –
9 = E09: –
10 = E10: –
11 = E11: NO FOOTSWITCH Footswitch not connected correctly. Check footswitch connection.
12 = E12: NO MOTOR IN M1 Motor/handpiece not connected correctly. Connect motor/handpiece correctly.
13 = E13: TOO HIGH TEMPERATURE MOTOR M1 Motor/handpiece overheating. Allow connected handpiece to cool
or operate another handpiece on 2nd channel.
Note: A new handpiece cannot be used
immediately on the same channel!
14 = E14: NO MOTOR IN M2 see E12. see E12.
15 = E15: TOO HIGH TEMPERATURE MOTOR M2 see E13. see E13.
16 = E16: IRRIGATION PUMP NOT CLOSED “Pump lever” not closed correctly. Move lever to vertical position.
17 = E17: MOTOR BLOCKED OR WRONG M1 Connected handpiece does not respond Connect suitable handpiece
the selected mode or or
handpiece is blocked for a short time release foot pedal, take load off handpiece and
when starting start again.
18 = E18: MOTOR BLOCKED OR WRONG M2 see E17. see E17.
19 = E19: MOTOR STOPPED M1 Handpiece blocked during operation. Release foot pedal, take load off handpiece and
start again.
20 = E20: MOTOR STOPPED M2 see E19. see E19.
21 = E21: NO SCB MODULE Send device for repair
Error table UNIDRIVE ®
Technische Beschreibung
Fehlersuche
Technical description
Troubleshooting
Техническое описание
Выявление неисправностей