Storti husky DSS 90, Operation And Maintenance, Page: 89 / 109

35
EN
OPERATION AND MAINTENANCE
Sect. 5.6.1 AUGER UNCLOGGING (HUSKY MT)
If the machine stops due to clogged augers, follow the procedure below.
1) Switch the machine off,
remove the keys and put them in your pocket.
2) Remove the cardan shaft from the power takeoff (1, fig. 1).
3) Insert the supplied spanner (4, fig. 3) in the power takeoff (5, fig. 3) in order to turn it ANTICLOCKWISE (in the same
direction of the cardan) by approx. 15-20 revolutions. This enables removing possible clogging from the augers.
4) Put the cardan shaft (1, fig. 1) back on the power takeoff.
Sect. 5.6.2 AUGER UNCLOGGING (HUSKY DS)
If the machine stops due to clogged augers, follow the procedure below. Remove the NIPPLE with great care in order not to
damage the aluminium ROTOFLUX joint.
1) Switch the machine off, remove the keys and put them in your pocket.
2) Remove the cardan shaft from the power takeoff (1, fig.1).
3) Remove the fitting with the pipe (2, fig. 1).
4) Remove the nipple (3, fig.1) taking care not to damage the aluminium
ROTOFLUX joint (4, fig.1).
5) Insert the supplied spanner (5, fig. 2) in the power takeoff (6, fig. 2) in order to turn it ANTICLOCKWISE (in the same
direction of the cardan) by approx. 15-20 revolutions. This enables removing possible clogging from the augers.
6) Release the auger, reinstall the
NIPPLE (3, fig. 1) with the copper washer: be careful not to tighten the ROTOFLUX joint
EXCESSIVELY and eventually damage it.
7) Put the fitting back with the pipe (2, fig. 1).
8) Put the cardan shaft (1, fig. 1) back on the power takeoff.
fig.1
1
2
fig.2
3
3
2
5
6
4
fig.1
1
fig.2