StorageTek L180, Service Manual

Page: 224 / 266

Seagate Ultrium Tape Drive
4-134 Fifth Edition 95897
Replacement
1. Set the drive on a work surface, making sure the cables away from the drive so that they
does not get pinched.
2. Slide the drive tray over the drive so that the cables do not get pinched.
3. Use a Torx T-10 bit to install the four screws on the bottom of the drive tray.
1. Screw (4)
2. Drive tray
CAUTION:
Possible ESD damage: Follow the ESD precautions outlined in
“Electrostatic
Discharge Damage Prevention” on page xxiii .
4. Connect the SCSI cable, TTI cable, and the power cable to the drive.
Note: Ensure that the jumper that enables TERMPWR for the drive is in place. The pins and
jumper are next to the power cable connection on the rear of the drive. Refer to the
L180 Tape Library Installation Manual,
PN 95896, for details. (You do not have to be
concerned about the jumpers that set the SCSI address. Those settings will be
ignored.)
1. SCSI cable connection
2. Power cable connection
3. TTI cable connection
C67312
1
2
C67311
Seagate
1 2 3