StorageTek L180, Service Manual

Page: 213 / 266

95897 Fifth Edition 4-123
IBM Ultrium Tape Drive
CAUTION:
Possible equipment damage: When sliding the drive into its slot, make sure the drive
SCSI cable is out of the way. Do not force the drive into the slot.
7. Slide the drive into its slot, being careful not to catch or crush any cables.
8. Tighten the thumbscrew on the left side of the IBM Ultrium drive.
9. Reconnect the interface cable (Fibre Channel or SCSI Y cable) to the rear of the drive.
CAUTION:
Possible equipment damage: Make sure the clip is on the Fibre Channel cable to
avoid damage when you close the drive access door.
10. Turn on the drive power by placing the switch to the ON (|) position.
1. Power switch
2. Screw locks
3. Thumbscrew
11. Close the drive access door (be careful not to break the Fibre Channel interface cable).
12. Push in and turn the snap rings and install the two screws.
1. Screw (2)
2. Snap rings (7)
13. Go to “Restoring Operation” on page 4-136 .
C67180
1
2
3
C67170
2
1