48
866-795-1586 • WWW.STONEAGETOOLS.COM
PRO-700-V2 PRODRAIN SET-UP
PRO-700 PRODRAIN SET-UP PROCEDURE
1. Attach the BOP 030 Collet Block to the Tripod Stand. Loosen two screws on one Collet Cap with a 1/4” Allen wrench. Slide the BOP
030 Collet Block onto the Tube Adapter located on the bottom end of the Tripod Stand. Tighten the two screws on the Collet Cap until
secure. The BOP 030 Collet Block Assembly can stay attached to Tripod Stand when not in use.
(Figure 1)
2. Attach the BOP 081-6 Snout Tube to BOP 030 Collet Block. Loosen two screws on the other Collet Cap with a 1/4” Allen wrench.
Slide the Snout Tube into the Collet Block and tighten the two screws until secure.
(Figure 1)
3. Attach the PRO 740 Weighted Splash Plate to the BOP 081-6 Snout Tube. Loosen two screws on the other Collet Cap with a 1/4”
Allen wrench. Slide the Weighted Splash Plate onto Snout Tube and tighten the Quick Release Lever until secure.
(Figure 1)
FIGURE 1
FIGURE 2
TUBE
ADAPTER
BOP 030
COLLET BLOCK
TRIPOD
STAND
BOP 081-6
SNOUT TUBE
QUICK
RELEASE
LEVER
COLLET
CAPS
PRO 740
WEIGHTED
SPLASH PLATE
4. Place the Tripod Stand Assembly over the drain. Center the Snout Tube into the drain and be sure that all three feet a planted firmly on
the ground.
(Figure 2)
DRAIN
FOOT
FOOT
FOOT
SNOUT
TUBE