13
866-795-1586 • WWW.STONEAGETOOLS.COM
FIGURE 1
FIGURE 2
4”-8” PLATE MOUNT ASSEMBLY SET-UP
PIPE
FLANGE
4”-8” FLANGE MOUNT PLATE (BOP 010-4-8)
1. Attach the 4”-8” Flange Mount Plate to the pipe flange using the fasteners that were removed from the flange joint. The nuts shown
between the flange and the Flange Mount Plate are to allow for drainage. Other spacer options are acceptable.
(Figure 1)
2. Align the appropriate slots or pre-drilled holes to the hole pattern on the flange. Adjust the Flange Mount Plate by sliding it along the slots
to center the inside diameter of the Hinge Clamp with the inside diameter of the pipe. Tighten all hardware to secure in place.
(Figure 2)
4. Loosen the adjustable handle on the Hinge Clamp. Slide the Snout Tube into the 4”-8” Plate Flange Mount. Tighten the adjustable
handle to secure. The 4”-8” Plate Flange Mount option is now ready to be loaded with the high pressure hose.
(Figure 4)
Go to page
17, “Hose and Collet Installation” for instructions.
FIGURE 4
BOP 081-6
SNOUT TUBE
ADJUSTABLE
HANDLE
3. Loosen the screws on both collet cap blocks. Slide the BOP 030 Collet Block Assembly onto the guide tube on the ABX-PRO and
tighten the two screws until secure. Slide the BOP 081-6 Snout Tube into the BOP 030 Collet Block Assembly. Push the Snout Tube in
until it stops, then tighten the two until secure.
(Figure 3)
BOP 030 COLLET
BLOCK ASSEMBLY
BOP 081-6
SNOUT TUBE
COLLET CAP
BLOCKS
GUIDE
TUBE
AUTOBOX
®
ABX-PRO
TRACTOR
FIGURE 3