14
866-795-1586 • WWW.STONEAGETOOLS.COM
STRAP MOUNT ASSEMBLY SET-UP
The Strap Mount Assembly (BOP 050) is designed for pipes that do not have flanges.
1. Attach the strap end to the strap capture bar and wrap the strap around the pipe towards the Winch Assembly.
(Figure 1)
2.
Pull excess strap through the Winch Assembly and tighten down with the Ball End Handle.
(Figure 2)
FIGURE 1
FIGURE 2
STRAP END TO
CAPTURE BAR
MALE
POSITIONER
BAR
WINCH
ASSEMBLY
STRAP
BALL END
HANDLE
PULL EXCESS
STRAP THROUGH
STRAP MOUNT ASSEMBLY (BOP 050) - MALE POSITIONER SIDE
Flanged pipe shown for
graphic representation only.
Not included in assembly.
STRAP MOUNT ASSEMBLY (BOP 050) - FEMALE POSITIONER SIDE
1. Loosen the screws on both collet cap blocks. Slide the BOP 030 Collet Block Assembly onto the guide tube on the ABX-PRO and
tighten the two screws until secure. Slide the BOP 081-6 Snout Tube into the BOP 030 Collet Block Assembly. Push the Snout Tube in
until it stops, then tighten the two until secure.
(Figure 1)
BOP 030 COLLET
BLOCK ASSEMBLY
BOP 081-6
SNOUT TUBE
COLLET CAP
BLOCKS
GUIDE
TUBE
AUTOBOX
®
ABX-PRO
TRACTOR
FIGURE 1