CLAMP FLATS
IN A VISE
ANTI-SEIZE
NOTICE
If reusing parts instead of replacing them;
• Wash
all parts thoroughly in solvent and blow dry
before assembling.
• Clean
any blockages or debris from the weep
holes in the head with a pin.
• Inspect
the Spring and the channels of the
Poppet for wear.
• Inspect
all O-Rings for wear and tearing.
• Inspect
the threads of the Inlet Nut for wear.
WGR SWITCHER ASSEMBLY
ASSEMBLY
1. To begin reassembly, install the O-Ring into
the groove in the Bushing and the three
O-Rings onto the Cartridge Assembly. Apply
grease to all the O-Rings.
Spring
Poppet
GREASE
PUNCH
Bushing
Yellow ThreadMate
™
& Teflon Tape
Switcher
Head
GREASE
ANTI-SEIZE
= Swagelock
®
Blue Goop or Equal
= Lithium Complex NGLI 1 or Equal
2. Install the prepped Front Jet into the Front
Port with a 3/8” Nut Driver.
3. Use the small punch to press the Cartridge
Assembly back into the Head. Use the Arbor
Press on the punch to tap the Cartridge
back into the Head evenly.
4. Install the Spring into the center of the
Cartridge Assembly.
5. Press the Poppet into the Head assembly
and rotate while pressing until its held in
place.
6. Apply grease on and around the O-Ring in
the Bushing.
7. Apply anti-seize to the threads of the
Bushing, and begin to hand tighten it into
the Head.
8. Secure the wrench flats of the Switcher
Head in a vise with the Bushingfacing up
and securely tighten the Bushing to the
Head with an Automotive Sliding Wrench,
Figure 33: For Step 1
Figure 34: For Steps 2-3
Figure 36: For Steps 6-8
O-Rings
(4)
Front Jet
Cartridge
Assembly
Figure 35: For Steps 4-5
Automotive
Sliding Wrench
(Not Included)
24
866-795-1586 • WWW.SEWERNOZZLES.COM
