GREASE
CLEAN
GREASE
WGR 058-M90
ShaftHP Seal
WGR 052
Wave Spring
TR200 121
O-ring
WGR 050
O-ring
WGR 184
HP Seal Press
WGR 102
Inlet Nut
Automotive
Sliding Wrench
(Not Included)
Large
Adjustable
Wrench
(Not Included)
CLAMP FLATS
IN A VISE
WGR 003
Body
BJ 026
Port Plug
Figure 21: For Steps 21-24
WG 014
Wave Spring
Figure 22: For Step 25
Figure 23: For Steps 26-27
21. Install the O-Ring (WGR 050) into the bore
for the Shaft HP Seal. Install the O-Ring
(TR200 121) into the groove before the start
of the Shaft threads. Grease both O-Rings
after installation.
22. Place the Wave Spring into the Shaft.
23. Apply a light coating of grease to the stem of
the Shaft HP Seal. Using the HP Seal Press
(WGR 184) gently press the Shaft HP Seal
into the Shaft. Rocking the Shaft HP Seal in
a small circular pattern while applying light
pressure may aid in installation. Pressing too
hard will damage or chip the seal. Always
use the Seal Install Tool to avoid damage to
the polished face. The Shaft HP Seal should
compress freely into the Shaft and spring
return.
24. Clean the polished face of the Shaft HP Seal
with Isopropyl alcohol. The polished face
needs to be clean and free from lint, grease
and oils.
25. Generously coat the Wave Spring with
grease. Drop into the Body on top of the
Bearing.
26. Apply anti-seize on the threads of the Inlet
Nut. Install the Inlet Nut tightly. (A torque of
115-135 ft-lb. is recommended)
27. Hold the tool at an angle so one of the ports
is the highest position, remove the Port
Plug to relieve any pressure built up from
installing the Inlet Nut then reinstall the Port
Plug.
GREASE
ANTI-SEIZE
ASSEMBLY
19
866-795-1586 • WWW.SEWERNOZZLES.COM
