5/32” Hex Key
(Not Included)
W
GR 020 or 022
Back Plate
WGR 004
Front Nut
CLAMP FLATS
IN A VISE
WGR 081/ 082
Fins (6)
GS 519-02
Screws (6)
GW 319-F-T06
Washers (6)
WGR 101
Shaft
SC 287 105
2½ Wrench
*Included in
WGR 612
KIT
CLAMP FLATS
IN A VISE
WGR 102
Inlet Nut
WGR 003
Body
WGR 180
Shaft
Lock Pin
WGR 040-
RXX-XXX
Head
TECH TIP:
Keep the flats of the Front Nut clamped down in
a bench vise on with the Inlet Nut facing up for
the next step.
BLUE
LOCTITE® 242
Figure 24: For Step 28
Figure 25: For Steps 29-31
28. Wrap a rubber band around the Body. Slide
each fin in place under the band to keep
them from falling out while installing the
back plate. Clean the threads of the six GS
519-02 Screws then apply Blue Loctite® 242
to the threads. Replace the Back Plate and
insert the Screws and evenly tighten in a star
pattern with a 5/32” Hex Key until they are all
tight. (A torque to 70 in-lb. is recommended).
29. Install the Head by clamping the flats in a
vise with the threads facing up.
30. Push the provided Magnum Shaft Lock
Pin through the first hole in the Front Nut,
locking the shaft in place.
31. Make sure the threads on the Shaft and
inside the Head are free from grit, debris,
and old Loctite®. Make sure the O-Ring on
the shaft is clean and in good condition.
Apply Blue Loctite® 242 to the Shaft threads
and install into the Head tightly. (A torque of
50 ft-lb. is recommended).
Figure 26: COMPLETE ASSEMBLY
BLUE
LOCTITE® 242
ASSEMBLY
20
866-795-1586 • WWW.SEWERNOZZLES.COM
