WGR SWITCHER PARTS
MODEL:
SWT
CC
CNP2 XXX Jets
9
9
GP 025-SS-P2 Plug
?
?
SA 062 O-Ring
4
4
WGR 060-R31 Head
1
WGR 060-R45-CC Head
0
1
WGR 061-1-1.75 Bushing
1
1
WGR 062 Cartridge Assembly
1
1
WGR 064 Poppet
1
1
WGR 066 Spring
1
1
WGR SWITCHER OVERVIEW
WGR SWITCHER MAINTENANCE TOOLS AND MATERIALS
DESCRIPTION AND INTENDED USE:
The Switcher is designed to allow an operator to
“switch” between a pulling/flushing mode and
a cleaning mode while using the same head.
This is made possible by an internal mechanism
called a Poppet. When flow is cycled on and
off, the Poppet redirects all flow to either the
pulling/flushing (back and front) jets or the
cleaning (side) jets. One Warthog Switcher Head
can perform a cleaning job that would normally
require two or more different heads with different
jet configurations. Utilizing the Switcher head
will increase both time and water consumption
savings. The design is more efficient because all
of the flow is directed to exactly where it is most
useful for either pulling/flushing or cleaning.
Bushing
Poppet
Product training and proper tools are required
to service this nozzle. If you are uncomfortable
performing the service, bring the nozzle to your
authorized dealer.
Take care throughout the entire procedure to
keep the internals clean and free from grit, lint,
and contamination. Failure to do so could result
in premature failure after service. See complete
Disassembly and Assembly instructions in this
manual.
For maintenance video:
https://www.youtube.com/playlist?list=PL-
XpY7HhmpxVkccu1zG45Wh5w0Vy3MwZ0
Spring
O-Rings
Cartridge
Assembly
WGR 060-R31 Head
WGR 060-R45-CC
Control Clean Head
The Control Clean Head
can be identified by the
groove in the center
Jets/Plugs
NECESSARY TOOLS:
• 3/8” Nut Driver
• Arbor Press
• Automotive Sliding Wrench
(18” Crescent® C718 Automotive Wrench)
• Bench Vise
• Pick
• Pin or needle
• Small Punch
NECESSARY MATERIALS:
• Clean lint free rags or blue shop towels
• Anti-Seize - Swagelok® Blue Goop®
StoneAge PN (GP 043)
• Grease - Lithium Complex NLGI 1
StoneAge PN (GP 048)
• When installing jets, StoneAge uses
Parker
®
Yellow ThreadMate and Teflon
Tape or an equivalent combination on the
threads of each jet.
Figure 27: SWITCHER ASSEMBLY
21
866-795-1586 • WWW.SEWERNOZZLES.COM
