Front
Port
Nose
Cartridge
Assembly
WGR SWITCHER DISASSEMBLY
DISASSEMBLY
1. Secure the wrench flats of the Switcher Head
in a vise with the Bushing facing up.
2. Using an Automotive Sliding Wrench, break
the Bushing loose from the Head and contin-
ue to remove it by hand.
Figure 28: For Steps 1-2
Bushing
Figure 29: For Step 3
Poppet
Spring
6. Use a pick to remove the O-Ring in the
groove of the Bushing, and the three O-Rings
on the Cartridge Assembly.
Front Jet
Figure 30: For Step 4
Figure 31: For Step 5
PUNCH
O-Rings
(4)
Figure 32: For Step 6
3. Within the Switcher, there is a Poppet with a
Spring beneath it. Push and turn the Poppet
inwards until it can be removed. Set the Pop-
pet and Spring aside.
4. Remove the Front Jet from the Front Port with
a 3/8” Nut Driver.
5. To remove the Cartridge Assembly from the
Head, place the Head on the Arbor Press with
the Front Port facing up. Locate the nose of
the Cartridge Assembly through the Front
Port. Insert a small punch to contact the nose
inside the head and an Arbor Press to push
down on the punch to release the Cartridge
Assembly.
Automotive
Sliding Wrench
(Not Included)
CLAMP FLATS
IN A VISE
23
866-795-1586 • WWW.SEWERNOZZLES.COM
