WGR 010
Shaft Seal
WGR 058-M90
Shaft HP Seal
WGR 011
Seal Spacer
WGR 052
Wave Spring
TR200 121
O-ring
WGR 101
Shaft
WGR 101
Shaft
WGR 009
Bearing
WGR 050
O-ring
WGR 186
HP Seal
Puller
Figure 11: For Steps 14-15
Figure 12: For Steps 16-17
INSPECT
Bearing
Splitter
INSPECT
INSPECT
INSPECT
INSPECT
14. Squeeze the HP Seal Puller together and
insert it into the bore of the Shaft HP Seal,
then release. The HP Seal Puller should
hook the bottom edge of the Shaft HP Seal;
pull upward in a circular pattern to work the
Shaft HP Seal out of the Shaft. Remove the
Wave Spring. Removing the Shaft HP Seal is
required to prevent it from being damaged
while removing the Bearing in the next step.
Inspect the polished faces, if damaged,
replace HP Seal set and together.
15. Use a pick to remove the O-Rings from the
Shaft. Do not scratch the glands in the shaft
otherwise leakage may occur.
16. Evenly seat a Bearing Splitter under the Rear
Bearing then press on the end of the Shaft
to remove Bearing. Use care to not catch or
bend the Seal Spacer. The Seal Spacer and
Shaft Seal will then slip off the shaft.
17. Inspect the Shaft for grooving where the
four shaft seals and bearing ride for signs
of the bearings slipping or scratches
which extend into the area where the seals
operate. Inspect the front shaft lock grooves
for interfering deformation. Remove burrs or
high spots by gently grinding or filing. If any
place is severely damaged or worn, the shaft
may need to be replaced.
DISASSEMBLY
15
866-795-1586 • WWW.SEWERNOZZLES.COM
