Stone Age WARTHOG WGR MAGNUM Series, User Manual

Page: 14 / 32

Automotive
Sliding Wrench
(Not Included)
WGR 003
Body
WGR 003
Body
WGR 010
Shaft Seal
WGR 059-M90
Nut HP Seal
WGR 006
Shaft Seal
WGR 006
Shaft Seal
WGR 008
O-Ring
WGR 008
O-Ring
WGR 076
O-Ring
WGR 011
Seal Spacer
WGR 052
Wave Spring
WGR 009
Bearing
WGR 050
O-ring
WGR 102
Inlet Nut
WGR 004
Front Nut
CLAMP
FLATS
IN A VISE
WGR 004
Front Nut
Figure 6: For Step 9
WGR 181
Removal
Tool
WGR 186 HP
Seal Puller
Figure 7: For Step 10
Figure 8: For Step 11
Figure 10: For Step 13
INSPECT
9. Carefully clamp the flats of the Body down
in a bench vise. Using a Automotive Sliding
Wrench, remove the Front Nut from the
Body.
10. Flip the Body over and place onto an Arbor
Press. Seat the Removal Tool against the
inside of the Shaft Seal to press the Shaft
Seal, Seal Spacer, and Bearing out of the
Body.
11. Using a pick, remove the Shaft Seal and
O-Ring from the Front Nut.
12. Using a pick, remove the Shaft Seal and
both O-Rings from the Inlet Nut. Use care
to not scratch or damage the seal bore or
glands of the Inlet Nut otherwise leakage
may occur.
13. Squeeze the HP Seal Puller together and
insert it into the bore of the Nut HP Seal,
then release. The HP Seal Puller should
hook the bottom edge of the Nut HP Seal;
pull upward in a circular pattern to work the
Nut HP Seal out of the Inlet Nut. Using a
pick remove the Wave Spring and O-Ring.
Inspect the polished faces, if damaged,
replace HP Seal set together.
PRESS
Figure 9: For Step 12
DISASSEMBLY DISASSEMBLY
14
866-795-1586 • WWW.SEWERNOZZLES.COM