Stone Age WARTHOG WGR MAGNUM Series, User Manual

Page: 17 / 32

WGR 004
Front Nut
WGR 003
Body
WGR 003
Body
WGR 010
Shaft Seal
WGR 011
Seal Spacer
WGR 009
Front Bearing
WGR 182
Install Tube
BJ 026
Port Plug
BJ 026
Port Plug
(Hand
tighten only)
WGR 101
Shaft
WGR 003
Body
ANTI-SEIZE
Lip Spring
Side
TECH TIP:
Before proceeding; The use of an Arbor Press
and Install Tube (WGR 182) is recommended for
the next three steps.
Figure 16: For Steps 8-10
Figure 17: For Step 11
GREASE
GREASE
GREASE
GREASE
8. Lightly coat the Shaft Seal with grease.
Install with the Shaft Seal with the lip spring
facing toward the center of the Body. Install
the Seal Spacer on top of the Shaft Seal.
9. Pack and coat every surface of the Front
Bearing with grease. Install the Front Bearing
and into the Body on top of the Seal Spacer.
10. Install the both Port Plugs (BJ 026). Hand
tighten the one closest to the Inlet Nut end.
11. Install the assembled Front Nut. Apply anti-
seize to the threads of the Body and torque
to 115-135 ft-lbs.
12. Flip the Body over so the Front Nut faces
down.
13. Lightly coat the Shaft with grease where
the Shaft Seals and Bearings ride. Gently
insert the Shaft into the Body then push the
Shaft into place by hand. The shoulder on
the Shaft should stick out slightly from the
Front Nut.
Figure 18: For Steps 12-13
ASSEMBLY
17
866-795-1586 • WWW.SEWERNOZZLES.COM