29
Assembly wall console
After the exact orientation the collector is fixed on the outside with
fastening plates at the upper and lower elongated hole on the
console.
1400008 Collector fastening set onto support
edge (2 fastening points)
Please note that the remaining fastening plates are to mount on the
opposite outer side.
Before the following collectors can be mounted, the compensator
must be mounted on the concisely protruding flange.
It is important to ensure that the 0-ring seal is used for the
compensator.
1300001 Collector connection set hydraulical
Fixation of the compensator on one side with the clamp.
Before tightening of the screw the clamp must be positioned by a
rotary motion up and down. Tighten the screw on the clamp only
manually. The use of cordless drills or similar may cause damages
on the thread of the clamp. Tighten the clamp until the two lugs
superimpose in the whole length.
1910001 Tool set
Afterwards, mount the fastening plate “double” on the next console
in the upper and lower elongated hole. The final fixation takes place
after assembly of the next collector.
1400006 Collector fastening set onto support
(2 fastening points)
Pre-installed compensator with 0-ring seal and clamp. Install the
upper and lower compensator according to the opposite figure.
