26
Assembly mounting profiles/
console
Dachhaken
Readily mounted tile clamps for one collector field with two collec-
tors.
Top: Tiles left out and clamp set with mounting tabs assembled
Bottom: Tiles coarsly ground and clamps assembled without
mounting tabs
Place the square bolts laterally into the profile into any groove.
1400026 Profile set Alu 200V, 240V and 270V or
1400035 Profile set Alu 200H or
1400027 Profile set Alu 240H or
1400028 Profile set Alu 270H
1400024 Fastening set for profile set on roof hooks (4 fast. pts.)
for every additional collector in one row
1400023 Fastening set for profile set on roof hooks (2 fast. pts.)
Fix the square bolts with the washer and the nut after putting it
through the slot.
Do not exceed the T-head screw‘s tightening torque of 27 Nm.
The slots in the hooks are for evening out bumps. The fastening of
the profile must be realised in the upper third of the slot.
In the border area of the fastening profile to be mounted the
connection profile has to be put in and centered; also at an angle of
90° to the square bolts.
Before joining the fastening profiles and connecting them with the
connection profile, the correct position is to be checked (level, line
mark). Subsequently, fix all setscrews M8x12 mm (connection set
and stop set).
1910001 Tool set
1400022 Connection set for profile set
After the roof hooks and mounting profiles are fixed, then you screw
the preassembled floor console with mounting profile. Remember to
mount the other consoles, the mounting dimensions on page 9.
The mounting of the collectors is described on the consoles on
page 12 and 13.
1400045 Fastening set console on profile
