HLG01 Page
12
V1.0
© 2007 Stevens AeroModel. All Rights Reserved.
8. Locate the 2mm id rubber bushing this part looks like a “top hat”. Using a 1” T-Pin make
a hole that measures 3/32” back from inside edge of rubber hat bushing (first photo).
Thread the needle that is installed to the timer top assembly through the hole you made
in the rubber bushing from the inside out (second photo). Then, slide bushing down on
aluminum shaft as illustrated (third photo). Use wire cutters to clip the remaining length
of T-Pin even with the outside edge of the timer top assembly (fourth photo).
9. Locate the 0.07g of viscous putty and load into timer cavity of fuselage assembly. Work
the putty in to where there are no air pockets then level with outer edge of fuselage as
illustrated.
10. With the putty installed within the timer cavity use four of the #0x3/16” sheet-metal
screws to secure the timer top assembly to the fuselage as illustrated below.